GE FANUC SERIES 90-30 PLC Digital I/O Module IC693MDL753 FACTORY SEALED
 
 
 
 
Product Description:

GE Fanuc Discrete input module for 90 – 30 series PLC offers 16 input points with one common power input terminal. It requires an AC power source for convenient operation. Module has LED indicators at the top to offer ON/OFF status of each point. Module has circuit wiring information on the surface towards the inside and circuit identification information on the outside surface. Module has a voltage rating of 120 VAC at 50/60 Hz, 0 – 132 VAC at 50/60 Hz, input current rating of 12 milli-Amps and a power rating of 90 milli-Amps at 5 VDC. It has a maximum ON response time of 30 milli-seconds and maximum OFF response time of 45 milli-seconds. Module is compatible with input devices such as pushbuttons, limit switches and electronic proximity switches. Input/output module provides the interface between the PLC and external input devices such as proximity sensors, push buttons, switches and BCD thumbwheels. It supports different voltage ranges, types, current capacity, isolation and response time to meet your application.
 
 
 
 
Product Details:
 
Input modules provide the interface between the PLC and external input devices such as proximity sensors, push buttons, switches and BCD thumbwheels. Output modules provide the interface between the PLC and external output devices such as contactors, interposing relays, BCD displays and indicator lamps. This module requires an AC power source, it cannot be used with a DC power source.
 
 
 
 

Product Summary:

• Rated Voltage: 12 through 24 volts DC, positive logic
• Outputs per Module: 32 (four groups of eight outputs each)
• Inrush Current: 5.4 amps for 10 ms
• On-state Voltage Drop: 0.3 volts DC
• Off-state Leakage Current: 0.1 mA maximum

• Description: Output Module 12/24 VDC
• Off-state Leakage Current: 0.1 mA maximum
• On Response Time: 0.5 ms maximum
• Off Response Time: 0.5 ms maximum
• Internal Power Consumption: 260 mA (maximum) from 5 volt bus on backplane; (13 mA + 3 mA/point ON + 4.7 mA/LED)
• Direct Method: This method uses cables that have a mating female connector on the module end and stripped and tinned wires on the other end. You can purchase a pair of pre-wired cables, catalog numbers IC693CBL327 and IC693CBL328 or, if required for your application, build your own cables. Refer to Building Cables for 24-Pin Connectors in the IC693CBL327/328 data sheet in Appendix C of this manual for more information.
• Using a TBQC: The Terminal Block Quick Connect method uses a pair of cables with connectors on each end. These connect from the module connectors to connectors on DIN?rail mounted terminal blocks.The TBQC components are discussed in Appendix D.

• Type if Device: 12/24 Volt DC, 0.5A Positive Logic Output, 32 Point, Series 90-30 Programmable Logic Controller
• Rated Voltage: 12 through 24 volts DC, positive logic
• Outputs per Module: 32 (four groups of eight outputs each)
• Isolation: 1500 volts between field side and logic side; 250 volts between groups
• Output Current: 0.5 amps per point with 4 amps maximum per group and 3 amps maximum per group common pin
• Inrush Current: 5.4 amps for 10 ms
• On-state Voltage Drop: 0.3 volts DC