GE FANUC IC693MDL330 TYPICAL SCAN RATE SERIES 90-30 PROCESSOR MODULE

 

for IC693MDL330

Brand GE Fanuc
Series Series 90-30
Part Number IC693MDL330Â
Brand GE Intelligent Platforms/GE Fanuc
Product Type Output Module
Rated Voltage 120 to 240 V AC
Output Voltage Range 85 to 264 V AC

Outputs 8
Isolation between field side and logic side 1500 V
Max. Inrush Current Per Cycle 20 A
Minimum Load Current 100 mA
Max. Output Voltage Drop 1.5 V
Output Current Per Point 2 A

 

About IC693MDL330

The IC693MDL330 module is an output module and a product of the GE Intelligent Platforms/GE Fanuc. It belongs to Series 90-30. It has a voltage rating of 120 to 240 Volts AC with 2 Amps of current. This module has 4 output points in each of the 2 isolated groups for a total of 8 outpoints. The 2 commons in the groups are not connected to the IC693MDL330 module. Therefore, each group can perform on completely separate AC-supplied phases, but they can also run on the same power supply. Each group comes with a protection fuse rated at 5 Amps for each common, and each output has an RC snubber to protect it from the transient electrical noise from the power line. This module has an output voltage range of 85 to 264 Volts AC, a frequency of 50 to 60 Hertz, and a maximum current of 2 Amps per point. At 40 degrees celsius, the maximum current per group is 4 Amps.

 

 

The GE Fanuc IC693MDL330 module offers a high level of inrush current (about 10 times the rated current and a maximum of 20 Amps per cycle, thus making the outputs best for use in the control of incandescent as well as inductive loads). It comes with a minimum load current of 100 milliamps. The IC693MDL330 module does not support DC power, and the users are required to provide AC power for the loads connected to the outputs. This module comes with LED indicators, which display the “ON” and “OFF” status for every point. Additionally, it features 2 horizontal rows with 8 green LEDs each and one additional red LED placed between the 2 rows. The 8 upper LEDs are marked A1 to A8, and they are used to indicate the output status. The red “F” LED turns on in case of a blown fuse.

 

 

 

 

Introductionof Technology CO.,LTD

1.
2.
3.

.

 

1.
2.
3.