Mô đun 24 V DC Output Module , Digital I/O Module ABB 3BSE050198R1 CPU Board PM866K01
đại lý PM866K01 | nhà phân phối PM866K01
ABB 3BSE050198R1 CPU Board PM866K01 Digital Input Output Module 24 V DC
Introduction
Digital Input Output Module PM866
The CPU board contains the microprocessor and RAM memory, a real-time clock, LED indicators, INIT push button, and a CompactFlash interface.
The base plate of the PM866 / PM866A controller has two RJ45 Ethernet ports (CN1, CN2) for connection to the Control Network, and two RJ45 serial ports (COM3, COM4). One of the serial ports (COM3) is an RS-232C port with modem control signals, whereas the other port (COM4) is isolated and used for the connection of a configuration tool. The controller supports CPU redundancy for higher availability (CPU, CEX-Bus, communication interfaces and S800 I/O Digital Input Output Module).
Simple DIN rail attachment / detachment procedures, using the unique slide & lock mechanism. All base plates are provided with a unique Ethernet address which provides every CPU with a hardware identity. The address can be found on the Ethernet address label attached to the TP830 base plate.
Features and benefits
-
Reliability and simple fault diagnosis procedures
-
Modularity, allowing for step-by-step expansion
-
IP20 Class protection without the requirement for enclosures
-
The controller Digital Input Output Module can be configured with 800xA control builder
-
The controller has full EMC certification
-
Sectioned CEX-Bus using a pair of BC810 / BC820
-
Hardware based on standards for optimum communication connectivity (Ethernet, PROFIBUS DP, etc.)
-
Built-in redundant Ethernet Communication ports
General Info
| Article number |
3BSE076939R1 (PM866AK01), |
| Redundancy | Yes |
| High Integrity | No |
| Clock Frequency | 133 MHz |
| Performance, 1000 boolean operations | 0.09 ms |
| Performance | 0.09 ms |
| Memory | 64 MB |
| RAM available for application | 51.389 MB |
| Flash memory for storage | Yes |
Detailed data
| Processor type | MPC866 |
| Switch over time in red. conf. | Max 10 ms |
| No. of applications per controller | 32 |
| No. of programs per application | 64 |
| No. of diagrams per application | 128 |
| No. of tasks per controller | 32 |
| Number of different cycle times | 32 |
| Cycle time per application programs | Down to 1 ms |
| Flash PROM for firmware storage | 4 MB |
| Power supply | 24 V DC (19.2-30 V DC) |
| Power consumption +24 V typ/max | 210 / 360 mA |
| Power dissipation typ. | 5.1 W (8.6 W max) |
| Redundant power supply status input | Yes |
| Built-in back-up battery | Lithium, 3.6 V |
| Real-time clock stability | 100 ppm (approx. 1 h/year) |
| Clock synchronization | 1 ms between AC 800M controllers by CNCP protocol |
| Event queue in controller per OPC client | Up to 3000 events |
| AC 800M transm. speed to OPC server | 36-86 events/sec, 113-143 data messages/sec |
| Comm. modules on CEX bus | 12 |
| Supply current on CEX bus | Max 2.4 A |
| I/O clusters on Modulebus with non-red. CPU | 1 electrical + 7 optical |
| I/O clusters on Modulebus with red. CPU | 0 eletrical + 7 optical |
| I/O capacity on Modulebus | Max 96 (single PM866) or 84 (red. PM866) I/O modules |
| Modulebus scan rate | 0 – 100 ms (actual time depending on number of I/O modules) |
| Supply current on Electrical Modulebus | 24 V : max 1.0 A 5 V : max 1.5 A |
| Ethernet channels | 2 |
| Ethernet interface | Ethernet (IEEE 802.3), 10 Mbit/s, RJ-45, female (8-pole) |
| Control Network protocol | MMS (Manufacturing Message Service) and IAC (Inter Application Communication) |
| Recommended Control Network backbone | 100 Mbit/s switched Ethernet |
| RS-232C interface | 2 (one general, 1 for service tool) |
| RS-232C interface (COM3) (non red. only) | RS-232C, 75-19 200 baud, RJ-45 female (8-pole), not opto isolated, full RTS-CTS support |
| RS-232C interface (COM4) (non red. only) | RS-232C, 9 600 baud, RJ-45 female (8-pole), opto isolated, no RTS-CTS support |
Digital Input Output Module PM866 Picture:
Some ABB items sold by WTL:
Good Service in WTL:
> We offer high quality, fast delivery, competitive price for ABB Input Output Module.
> Please send your RFQ to get the latest price.
> Normally, we will ship the items in 1-2 weeks after receive the payment.
> We can ship to you by UPS/DHL//EMS/Fedex. Please contact us and we will use your preferred ways.
> We have a large stock and the prices are variable, so sometimes the prices we post are not accurate. If needed, please contact us for specific prices.
Liability:
WTL is not liable for any personal injury or property damage resulting from the use of this equipment. It is
buyer’s responsibility as to the safe handling & operation of this equipment and to verify equipment is
compliance to their machinery.
Our Brands:
