GE FANUC SERIES 90-30 PLC Digital I/O Module IC693PBM200 FACTORY SEALED
 
 
 
 
Product Description:

 

GE Fanuc Discrete input module for 90 – 30 series PLC offers 16 input points with one common power input terminal. It requires an AC power source for convenient operation. Module has LED indicators at the top to offer ON/OFF status of each point. Module has circuit wiring information on the surface towards the inside and circuit identification information on the outside surface. Module has a voltage rating of 120 VAC at 50/60 Hz, 0 – 132 VAC at 50/60 Hz, input current rating of 12 milli-Amps and a power rating of 90 milli-Amps at 5 VDC. It has a maximum ON response time of 30 milli-seconds and maximum OFF response time of 45 milli-seconds. Module is compatible with input devices such as pushbuttons, limit switches and electronic proximity switches. Input/output module provides the interface between the PLC and external input devices such as proximity sensors, push buttons, switches and BCD thumbwheels. It supports different voltage ranges, types, current capacity, isolation and response time to meet your application.
 
 
 
 
Product Details:
 
Input modules provide the interface between the PLC and external input devices such as proximity sensors, push buttons, switches and BCD thumbwheels. Output modules provide the interface between the PLC and external output devices such as contactors, interposing relays, BCD displays and indicator lamps. This module requires an AC power source, it cannot be used with a DC power source.
 
 
 
 

 

Product Summary:

 

 

Type of Device: Profibus DP Master Module

 

 

 

 

• Description: PROFIBUS DP Master Module
• PLC Modes: While the PLC is in either of Run or Stop IOScan modes, the IC693PBM200 scans all configured slaves, sending outputs and reading inputs. When the PLC is not scanning I/O, the module continues to scan all I/O but enters Clear mode. In Clear mode, zeroed data is sent to all of the configured slaves. When the PLC again transitions to either Run or Stop IOScan mode, output transmission resumes using the most recentlysupplied output data
• Data Size Limitations: The amount of data that can be exchanged between the CPU and the IC693PBM200 module is limited to 3,972 bytes of input data (data going from the IC693PBM200 module to the CPU) and 3,972 bytes of output data (data going from the CPU to the IC693PBM200 module).
• Product Details: The size of the slave status area for the IC693PBM200 is 128 points by default, compared to the 64 points used by the HE693PBM101. The user may need to consider reducing the size of the slave status area to match the previous module?s usage.

 

 

• Type of Device: Profibus DP Master Module
• Configuration Requirements: Only ME Logic Developer PLC programming software version 3.0 or later can be used to configure the IC693PBM200 PROFIBUS DP Master module.
• CPU Firmware Requirement: CPU Release 8.00 or later is required; however, if configuring very large networks, CPU Release 10.60 or later is required.
• Computer System Requirements: Windows NT version 4.0 with service pack 4 or later, OR Windows 2000 Professional, OR Windows XP, OR Windows 98 SE, Internet Explorer version 5.0 or later.

 
 

 
 
 

 

 

 

 

 

 

• Sophey

• Telephone:-13798305309